Are Logicube duplicators compatible with Windows 7 operating system?
The Echo Plus, Sonix, SuperSonix, OmniClone Xi and OmniSAS products are compatible with Windows 7 operating system. Special instructions must be followed to clone Windows 7 drives using CleverCopy mode if the destination drive is larger than the source drive or if the source drives contains a "recovery" partion and Selective Partitions software is required. Please note that at this time, MasterManager is not compatible with Windows 7, compatibility will be provided in a future software update. Please see information in the Windows 7 Cloning Guideor the specific Logicube duplicator's users guide or contact our Technical Support department for assistance.
What is DDF?
DDF stands for the Common RAID Disk Data Format, a standard set by SNIA
What is SNIA?
SNIA stands for the Storage Networking Industry Association
Can I clone to/from drives larger than 80 Gigabytes?
Yes. The firmware was designed to support drives up to at least 1TB, in some cases larger than 1TB drives are supported. Check with Logicube Technical Support department for specific information on your model.
Can the Logicube OmniSAS clone disk drives from a RAID array?
Yes. OmniSAS software version 4.08 has improved compatibility for cloning disk drives from a RAID array. This applies to RAID disk drives from RAID arrays that use a RAID controller compliant with the SNIA (Storage Networking Industry Association), DDF (Common RAID Disk Data Format).
What type of RAID arrays can be cloned using the Logicube OmniSAS?
All types of RAID arrays can be cloned by the OmniSAS. For step-by-step instructions and for more information on cloning disk drives from a RAID array, see the RAID Cloning Guidelines section of the latest version OmniSAS Users Manual (v1.2 or later)
