 |
 |
Are Logicube duplicators compatible with Windows 7 operating system? |
 |
|
The Echo Plus, Sonix, SuperSonix, OmniClone Xi and OmniSAS products are compatible with Windows 7 operating system. Special instructions must be followed to clone Windows 7 drives using CleverCopy mode if the destination drive is larger than the source drive or if the source drives contains a "recovery" partion and Selective Partitions software is required. Please note that at this time, MasterManager is not compatible with Windows 7, compatibility will be provided in a future software update. Please see information in the Windows 7 Cloning Guide or the specific Logicube duplicator's users guide or contact our Technical Support department for assistance.
|
|
|
|
|
Can Logicube products clone mSATA (also known as mini-SATA) solid state drives? |
|
|
These solid state drives use a PCI-e connector with a SATA interface. To clone these type drives you will need to purchase an off-the-shelf mSATA to SATA drive adapter, such as the M-Factors MF25-mSATA http://www.mfactors.com/products/mSATA%252dto%252dSATA-adapter.html |
|
|
|
|
Can Logicube products be used with Panasonic Toughbook enclosures? |
|
|
Logicube solutions can be used with these enclosures, however, a special Panasonic SATA adapter must be used. These adapters can be purchased thorugh various online retail sites. Contact Panasonic directly for more information regarding this adapter. Part Number: CF-K30JG001, Description: CF-30/19/74/52 HDD Connector. |
|
|
|
|
Can I clone to/from drives larger than 80 Gigabytes? |
|
|
Yes. The firmware was designed to support drives up to at least 1TB, in some cases larger than 1TB drives are supported. Check with Logicube Technical Support department for specific information on your model. |
|
|
